WARNING
WARNING
(4) Inspect the battery box for dents, cracks,
and defective mounting bracket, clamps, and car-
rying strap.
(5) Remove all burrs and straighten minor
dents. Replace all defective parts that cannot be
repaired.
c. Reassembly. Refer to figure 5-17 for model
242406 or figure 5-18 for model USATS-79.
5-22. Hand Lamp and Electrical Cable.
a. General. When not in use, the hand lamp and
electrical cable are stowed in the battery box.
b. Disassembly. Refer to figure 5-19, model
242406 or figure 5-20, model USATS-79.
c. Cleaning, Inspection and Repair.
Clean parts in a well-ventilated area.
Avoid inhalation of solvent fumes and
prolonged exposure of skin to cleaning
solvent. Wash exposed skin thoroughly.
Dry
cleaning
solvent (Fed.
Spec.
P-D-680) used to clean parts is potential-
ly dangerous to personnel and property.
Do not use near open flame or excessive
heat. Flash point of solvent is 100F to
138F (38C to 59C).
(1) Clean all metal parts with cleaning solvent
and dry thoroughly.
(2) Inspect the lamps for defects. Inspect all
electrical contacts for breaks, wear, and corrosion.
(3) Inspect insulation for cracks, wear, and
damage. Inspect the electrical cable for breaks and
frayed insulation. Inspect the cable connectors for
breaks and defective terminals.
(4) Inspect the housing and body for dents,
rust, burns, and other defects.
(5) Remove all burns and straighten minor
dents. Replace all defective parts that cannot be
repaired.
d. Reassembly. Refer to figure 5-19 (model
242406) or figure 5-20 (model USATS-79) and
reassemble the hand lamp and electrical cable.
5-23. Eyepiece Adapter Assembly.
a. General. When not is use, the eyepiece
adapter assembly is stowed in the accessory case.
b. Disassembly. Refer to figure 5-12 and
disassemble the eyepiece adapter assembly.
c. Cleaninng, Inspection and Repair.
Clean parts in a well-ventilated area.
Avoid inhalation of solvent fumes and
prolonged exposure of skin to cleaning
solvent. Wash exposed skin thoroughly.
Dry cleaning solvent (Fed. Spec.
P-D-680) used to clean parts is potential-
ly dangerous to personnel and property.
Do not use near open flame or excessive
heat. Flash point ‘of solvent is lOOF to
138F (38C to 59 C).
(1) Clean all metal parts with an approved
cleaning solvent and dry thoroughly.
(2) Inspect the lamp for defects. Inspect the
contact springs for bends, wear, and fatigue. In-
spect the insulators for wear and damage.
(3) Replace all defective parts that cannot be
repaired.
d. Reassembly. Refer to figure 5-21 and
reassemble the eyepiece adapter assembly.
5-21
