TM 5-3610-287-24
3-13.
REPAIR SECTION BODY SKIN (PERMANENT ) (CONT)
WARNING
Do not attempt to remove Section body skin fragments by
pulling or cutting. Failure to observe this warning
may result in serious injury or further damage to
equipment.
1.
Bend broken edges of skin (1) into puncture (2).
2.
Remove loose fragments of foam (3).
3.
Use rag and water to clean puncture area. Wipe dry.
4.
Prepare sheet metal patch (4) large enough to cover damaged area.
5.
Place sheet metal patch (4) over damaged area and mark around edges of
patch.
6.
Remove sheet metal patch from Section and drill 13/64-inch (0.52 cm)
holes about 1 inch (2.54 cm) apart around edges of sheet metal
patch (4).
3-12
