TM 5-3610-286-20
2-95.
Control Register System.
This task covers:
a. Service
b. Replace
c. Inspect
d. Repair
INITIAL SETUP
Tools
0.050 x 0.375 x 8 in. flat-tip screwdriver
5 mm hex key
Ball-peen hammer
2 mm pin punch
a. Service. Lubricate as required. Refer to Operation of Auxiliary Equipment in
TM 5-3610-286-10.
b. Replace. If defects in the control register cannot be corrected by the repair procedures in this
paragraph, replace the unit.
c. Inspect.
(1) Inspect for loose or damaged punching units.
(2) Inspect for binding in lever rotation.
d. Repair. (figure 2-278)
(1) Remove four screws (1) and cover (2).
(2) Remove 16 socket-head screws (3),16 star washers (4), and eight set squares (5).
(3) Remove eight socket-head screws (6), eight spring tension pins (7), and four punching
units (8).
(4) Remove three screws (9), three Iockwashers (10), and punch holding beam (11).
(5) Replace any damaged or worn punching units.
2-546
