TM 5-3610-286-20
2-59.
Suction Drum Motor.
This task covers: a. Remove
b. Install
INITIAL SETUP
Tools
Additional Personnel Requirement
6 mm hex key
Electrician MOS 35E20
8 mm combination wrench
.046 x 0.3125 x 6 in. flat-tip screwdriver
a. Remove. (figure 2-134)
WARNING
Hazardous electrical voltages exist within printing press. Do not connector
disconnect any electrical components while power is on. Death, serious
electrical shock, or burns may result.
(1) Slide suction drum assembly (1) all the way out.
(2) Remove four hex-head screws (2) from motor side of coupling (3) and separate motor (4)
from gear box (5).
NOTE
Pull motor straight out from gear box.
(3) Remove four screws (6), terminal box cover (7), and gasket (8) from back of motor (4).
Retain gasket.
(4) Loosen slotted ground screw (9) and remove green/white ground lead.
(5) Loosen terminal nuts on connector terminals (10) and tag and remove three black phase
leads.
2-304
