TM 5-3610-286-20
2-41.
Bearing Bolt Assembly.
This task covers:
a. Replace
b. Repair
INITIAL SETUP
Tools
Equipment Conditions
Retaining-ring pliers
Dampening fountain assembly removed (para. 2-37)
Ball-peen hammer
Dampening vibrator roller removed
10 mm combination wrench
(TM 5-3610-286-10)
Main guard (D/S) removed (para. 2-20)
a. Replace. (figure 2-86)
WARNING
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
2-214
Spring under compression is released
Remove two hex-head screws (1), two washers (2),
spring (4).
Remove retaining ring (5).
when performing step 1.
cover plate (3), and compression
Slide bearing bolt (6) through side frame and remove.
Pull needle bearing (7) from bearing bolt (6).
Install needle bearing (7) into bearing bolt (6).
Install bearing bolt (6) into side frame.
install retaining ring (5).
Install compression spring (4), coverplate (3), two washers (2), and two hex-head
screws (1).
