TM 5-3610-286-20
2-34.
Distributor Roller Latch Assembly.
This task covers:
a. Remove
b. Repair
c. Install
INITIAL SETUP
Tools
Equipment Conditions
Retaining-ring pliers
Distributor roller No. 16 removed
0.050 x 0.375 x 8 in. flat-tip screwdriver
(TM 5-3610-286-10)
3 mm punch pin
8 mm punch pin
10 mm combination wrench
a. Remove. (figure 2-65)
(1) Pull latch (1) towards feeder end of press and remove set screw (2).
(2) Release latch and remove compression spring (3).
(3) Remove retaining ring (4), washer (5), and latch (1).
(4) Loosen nut (6) and remove spring rod (7).
(5) Remove one short socket-head screw (8), long socket-head screw (9), two washers
(10), and guide piece (11).
(6) Remove spring rod guide (12).
(7) Remove pin (13).
b. Repair. (figure 2-65)
(1) Remove pin (14) and rod head (15).
(2) Replace worn or stripped thread rod head.
(3) Replace rod head (15) and pin (14) in latch (1).
(4) Replace worn or broken latch (1).
(5) Replace weak or broken compression spring (3).
(6) Replace broken or missing set screw (2).
2-176
