TM 5-3610-286-20
2-32.
Ductor Roller Swing Mechanism.
This task covers:
a. Remove
b. Repair
c. Install
INITIAL SETUP
Tools
Equipment Conditions
Retaining-ring pliers
Main guard and accessories assembly (D/S)
5 mm hex key
removed (para. 2-20)
6 mm hex key
Lubrication and distribution components
3 mm pin punch
removed (para. 2-78)
10 mm combination wrench
Ink fountain assembly removed (para. 2-24)
Ball-peen hammer
a. Remove. (figure 2-59)
(1) Remove two socket-head cap screws (1) and washers (2).
(2) Remove retaining ring (3), washer (4), and support piece (5) with roller bearing (6).
(3) Remove hex nut (7) washer (8), and bearing bolt (9).
(4) Remove retaining ring (10) and washer (11).
(5) Remove tapered pin (12), pin (13), and pull rod (14) with two needle bearings (15).
(6) Remove pull rod (16) with two needle bearings (17).
(7) Remove hex nut (18), washer (19), and bearing bolt (20).
(8) Remove swing piece (21).
(9) Remove retaining ring (22) and pull rod (23) with two needle bearings (24).
(10) Remove two supporting bolts (25).
2-164
