TM 5-3610-286-20
2-31.
Roller Adjusters and Feeler Rods (cont).
c. Install. (figure 2-58)
(1) Replace worm gear housing (1), two washers (2), and socket-head screws (3).
(2) Aline worm gear(4) in worm gear housing (1) and replace bearing bracket (5), two
washers (6), and two socket-head screws (7).
(3) Install bearing bracket (8), two washers (9), and two socket-head screws (10).
(4) Install compression spring (11), roller control rod (12), and hex nut (13).
(5) Install spring rod (14) and hex-head screw (15).
d. Aline. (figure 2-58)
(1) Loosen socket-head screws (7).
(2) Rotate adjuster knob (16) until worm gear (4) seats fully in worm gear housing (1) and
turns without binding.
(3) Tighten socket-head screws (7).
NOTE
FOLLOW-ON MAINTENANCE:
(1) Install roller guide rails (para. 2-25).
(2) Install inking rollers (TM 5-3610-286-10).
2-162
