TM 5-3610-286-20
2-24.
Ink Fountain Assembly (cont).
c. Install.
(1) Ink fountain. (figure 2-37)
(a) Slide support bar (1) through bearings (2) in ink fountain (3) until each end of support
bar is flush with ink fountain side surfaces.
(b) Place wooden blocks in press to support ink fountain assembly.
Ink fountain assembly exceeds 35 pounds and requires two persons for
replacement.
(c) Using two persons, grasp ink fountain (3) on each end and install in press, resting on
blocks.
(d) Aline threaded holes in each end of support bar (1) with holes in O/S and D/S frames,
and install washers (4), hex bolts (5), and tighen bolts.
(e) Install lubrication distribution unit (6) and socket-head screw (7) and tighten screw.
(f) Install all rigid tube lubrication fittings on lubrication distribution unit (6) and remove
tags.
(g) Install two connecting links (8) and hex-head screws (9).
(h) Install ink roller.
2-114