TM 5-3610-286-20
2-22.
Manual Inking Roller Assembly.
This task covers:
a. Remove
b. Repair
c. Install
INITIAL SETUP
Tools
Equipment Condition
10 mm combination wrench
Main guard (D/S) removed (para. 2-20)
17 mm combination wrench
Upper guard (O/S) removed (para. 2-18)
5 mm pin punch
8 in. bronze punch
Additional Personnel Requirement
4 mm pin punch
0.050 x 0.375 x 8 in. flat-tip screwdriver
Printing and Binding Specialist, MOS 83F20
Ball-peen hammer
a. Remove.
NOTE
Removal of assembly requires extensive disassembly of lubrication system
components since assembly mounting bar is hollow and carries lubricating oil
from D/S to O/S of press. If only the roller needs removal, do not remove main
guard D/S or upper guard O/S and proceed to paragraph (1). To remove
entire assembly, remove guards and proceed to paragraph (2).
(1) Manual inking roller. (figure 2-25)
(a) Using handle (1) or handle (2), rotate manual inking roller (3) so that roller is in up
position.
(b) Remove two pins (4).
(c) Grasp roller and shift it towards D/S until O/S shaft end is free of lever (5).
2-90
