TM 5-3610-286-10
3-15.
FEEDER TAPE MAINTENANCE INSTRUCTIONS
This task covers:
a. Replacement b. Adjustment
INITIAL SETUP
Tools
Feeder tape gluing device (appendix B, section III, item 13)
Materials/Parts
Feeder tape (appendix D, item 71)
Feeder tape glue (appendix D, item 25)
Single-edge razor blade (appendix D, item 5)
General Safety Instructions
WARNING
EXPOSED MOVING PARTS.
All adjustments will be made while
Printing Press is on SAFETY STOP except those authorized by this
manual to be made with Printing Press running.
Printing Press
must be on safe at all times when not in motion. Always shout
“clear” and wait for “clear” response before taking Printing
Press off safe to inch or run. Failure to follow this warning
may result in serious injury.
REPLACEMENT
NOTE
There is no need to remove feeder
maintenance on any part of feeder
tapes to perform
table.
If feeder tape
becomes frayed from wear, cut tape and remove.
1.
Plug in feeder tape gluing device (1) to warm up.
3-41
