TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
e. Prepare Inking Assembly (Cont)
(c) Put Printing Press on safe.
Insert L-handle special wrench (1)
into opening of inking unit side frame.
(d) Turn L-handle wrench to left until it stops.
(e) Remove oscillator roller no.
5 from delivery end of Printing
Press and place on delivery gripper cover roller supports.
(f) Slide distributor roller no. 10 out of Printing Press.
(g) Loosen locknut, back off locking knurled adjustment screws, and
remove rider roller no. 13.
2-75
