TM 5-3610-285-14
Section IV ORGANIZATIONAL MAINTENANCE
10-11. LUBRICATION INSTRUCTIONS . This equipment does not require lubrication.
10-12. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE); AND
SUPPORT EQUIPMENT.
10-12.1 Common Tools and Equipment. For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your unit.
10-12.2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support Equipment. Special Tools, TMDE,
and Support Equipment is listed in the applicable repair parts and special tools list and in Appendix B of this manual.
10-12.3 Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List, TM 5-3610-285-
24P covering organizational maintenance for this equipment.
10-13. SERVICE UPON RECEIPT.
10-13.1 Checking Unpacked Equipment.
a.
Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the
damage on DD Form 6, Packing Improvement Report.
b.
Check the equipment against the packing list to see if the shipment is complete. Report all discrepancies in
accordance with the instructions of DA Pam 738-750.
c.
Check to see whether the equipment has been modified.
10-14. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES . There are no organizational
PMCS procedures assigned for this equipment.
10-15. ORGANIZATIONAL TROUBLESHOOTING PROCEDURES. There are no organizational troubleshooting
procedures assigned for this equipment.
10-16. MAINTENANCE PROCEDURES.
a.
This section contains instructions covering organizational maintenance functions for the support items.
Personnel required are listed only if the task requires more than one.
b.
After completing each maintenance procedure, perform operational check to be sure that equipment is properly
functioning.
10-29
