TM 5-3610-285-14
a.
Remove top cover.
b.
Remove crossovers and entrance crossover.
c.
Verify that feed tray is square with tie rod of developer rack assembly.
Place a sheet of film against the side guide of the feed tray, and manually feed approximately 1 in.
(25.4 mm) of film into the unit.
d.
Pull the leading edge of the film up to and square with the tie rod of the developer rack.
e.
If film is not square with the side guide, loosen the wingnuts under the feed tray. Square tray with edge
of film.
f.
Tighten wingnuts.
g.
Reinstall entrance crossover and crossovers.
h.
Replace top cover.
5-77
