TM 5-3610-285-14
2-10.2
Adjust Photodetector Assembly.
MOS:
83E, Photo and Layout Specialist
TOOLS:
Flat Tip Screwdriver
a.
Pull out frame release knob and flip glass frame into vertical position.
b.
Loosen center screw and turn dial to next highest digit to increase time value of one unit of light. Turn dial to
next lowest digit to decrease time value of one unit of light.
c.
Retighten screw and run test exposure.
d.
If necessary, repeat procedure until proper adjustment is obtained.
Section IV. ORGANIZATIONAL MAINTENANCE
2-11.
LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
2-12.
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE);
AND SUPPORT EQUIPMENT.
2-12.1
Common Tools and Equipment. For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your unit.
2-12.2
Special Tools; Test, Measurement, and Diagnostic Equipment; and Support Equipment. Special Tools,
TMDE, and Support Equipment is listed in the applicable repair parts and special tools list and in appendix B of this
manual.
2-36
