TM 5-3610-259-14
T a b l e 5 - 3 . ORGANIZATIONAL TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3.
TABLE DOES NOT LOCK - Cont
Step 4.
Check for defective tilt locking block.
(a) If good, proceed to step 5.
(b) If defective, replace (paragraph 5-16.6).
Step 5.
Check for defective tilt locking plate.
If defective, replace (paragraph 5-16.6).
5-16.
MAINTENANCE PROCEDURES.
This section contains instructions covering organizational maintenance
functions for the drafting, scribing/tracing table.
Personnel required are listed
only if the task requires more than one.
a .
b. After completing each maintenance procedure, perform operational check to
be sure that equipment is properly functioning.
INDEX
PROCEDURES
PARAGRAPH
Replace Power Switch . . . . . . . . . . . . . . . . . . . . . . . . . 5-16.1
Replace Power Cord . . . . . . . . . . . . . . . . . . . . . . . . . . 5-16.2
Replace Receptacle . . . . . . . . . . . . . . . . . . . . . . . . . . 5-16.3
Replace Lamp Ballast . . . . . . . . . . . . . . . . . . . . . . . . . 5-16.4
Replace Tube/Starter . . . . . . . . . . . . . . . . . . . . . . . . . 5-16.5
Repair Tilt
Replace Pill
Lock Assembly. . . . . . . . . . . . . . . . . . . . . . . 5-16.6
ow Block Assembly. . . . . . . . . . . . . . . . . . . . . 5-16.7
5-17
