TM 5-3610-259-14
2-10.2 Adjust Photodetector Assembly.
MOS: 83E, Photo and Layout Specialist
TOOLS: Flat Tip Screwdriver
a.
Pull out frame release knob and flip glass frame into vertical position.
b. Loosen center screw and turn dial to next highest digit to increase time
digit to decrease
value of one unit of light. Turn dial to next lowest
time value of one unit of light.
c.
Retighten screw and run test exposure.
d. If necessary, repeat procedure until proper adjustment is obtained.
Section IV.
ORGANIZATIONAL MAINTENANCE
2-11.
LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
2-12. REPAIR PARTS. SPECIAL TOOLS: TEST. MEASUREMENT. AND DIAGNOSTIC EQUIPMENT
(TMDE);
AND
SUPPORT-EQUIPMENT.
2-12.1 Common Tools and Equipment. For authori
refer to the Modified Table of Organization and
unit.
zed common tools and equipment,
Equipment (MTOE) applicable to your
2-12.2 Special Tools: Test, Measurement, and Diagnostic Equipment; and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in appendix B of this manual.
2-36
