TM 5-3610-259-14
(2) Reaching down through top of unit, remove two hex head screws and clamps
from each side of reflector.
(3) Carefully remove glass light shield from glass holder on wall.
(4), Use cheesecloth moistened with glass cleaner to clean both sides of glass
surface.
CAUTION
To prevent damage to equipment, two persons are required to reinstall glass light
(5) Using white gloves, carefully set glass light shield into position over
the exposure lamp and reflector.
(6) Reinstall glass clamps and hex head screws.
(7) Rotate glass frame into its horizontal position and lock into place with
frame release knob.
(8) Turn on circuit breaker and platemaker main power switch.
2-16
