TM 5-3610-257-14
1-10.3. Replace Battle Lamp/Dome Light.
MOS:
83E, Photo and Layout Specialist
TOOLS:
None
SUPPLIES:
Light (12 V)
Silicone Spray (Item 47, Appendix E)
WARNING
Death or serious injury may occur if power is left on while servicing lamp.
NOTE
Battle lamp and dome light are sealed units. No bulb replacement is possible. Complete light
must be replaced.
a.
Set switch to OFF.
b.
Push light and gasket up into opening.
c.
Separate gasket from light.
d.
Tilt and remove light and gasket from opening.
e.
Disconnect defective light from connector.
f.
Connect new light to connector.
g.
Reinstall gasket in opening.
NOTE
The use of silicone spray on the gasket will help to position light.
h.
Position light in gasket and push in.
1-62
