TM 5-3610-257-14
Section IV. ORGANIZATIONAL MAINTENANCE
1-11.
LUBRICATION INSTRUCTIONS. This equipment does not require lubrication at this level of maintenance.
1-12.
REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE); AND
SUPPORT EQUIPMENT.
1-12.1. Common Tools and Equipment. For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your unit.
1-12.2. Special Tools; Test, Measurement. and Diagnostic Equipment; and Support Equipment. Special Tools,
TMDE, and Support Equipment is listed in the applicable repair parts and special tools list and in Appendix B of this
manual.
1-12.3. Repair Parts. Repair parts for this equipment are listed in the Repair Parts and Special Tools List, TM 5-3610-
257-24P covering organizational maintenance for this equipment.
1-13.
SERVICE UPON RECEIPT.
NOTE
The section may be received mounted on a chassis, or as a van body for mounting on an available
transporter, or onsite. Inspection of the chassis is covered in TM 5-2330-305-14. Inspection of the
air conditioner/heater is covered in TM 5-4120-367-14.
1-13.1. Checking Unpacked Equipment.
a.
Inspect the equipment for damage incurred during shipment. If the equipment has been damaged, report the
damage on DD Form 6, Packing Improvement Report.
(1)
Visually inspect the section exterior starting at the rear to cover rear, curbside, roadside, front, top, and
bottom. Inspect for damage, tears, breaks, or corrosion.
(2)
Enter section and inspect for broken equipment, tool boxes, chairs, or equipment loose and not secured.
(3)
Close doors and vents to determine if light leaks exist.
(4)
Inspect doors for damage, torn or rotted seals, and tightness of closure.
(5)
Inspect interior for evidence of water damage, fungi, mildew, or corrosion.
(6)
Report damage or discrepancies in accordance with AR 735-11 and AR 735-11-2.
1-63
