TM 5-3610-257-14
4-16.
ORGANIZATIONAL MAINTENANCE PROCEDURES.
a.
This section contains instructions covering Organizational maintenance functions for the densitometer.
Personnel required are listed only if the task requires more than one.
b.
After completing each maintenance procedure, perform operational check to be sure that equipment is
properly functioning.
INDEX
PROCEDURE
PARAGRAPH
Remove/Install Densitometer .............................................................................................................
4-16.1
Replace Probe Lamp..........................................................................................................................
4-16.2
Replace Filter .....................................................................................................................................
4-16.3
Replace READ Pushbutton ................................................................................................................
4-16.4
Replace Power ON/OFF Switch.........................................................................................................
4-16.5
Replace Fuse Holder..........................................................................................................................
4-16.6
Replace ZERO Control.......................................................................................................................
4-16.7
Replace Transformer .........................................................................................................................
4-16.8
Replace Voltage Selection Switch......................................................................................................
4-16.9
Replace SLOPE Control.....................................................................................................................
4-16.10
Replace Power Cord ..........................................................................................................................
4-16.11
Replace FOURTH-DIGIT ON/OFF Switch .........................................................................................
4-16.12
Replace Capacitor..............................................................................................................................
4-16.13
Replace Connector.............................................................................................................................
4-16.14
Aline Reflection Probe Optical System...............................................................................................
4-16.15
4-20