TM 5-3610-253-14
Section Ill. OPERATOR MAINTENANCE
6-8. LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
6-9. TROUBLESHOOTING PROCEDURES.
a. The table lists the common malfunctions which you may find during operation or maintenance of the shrink
wrap system, You should perform the test/inspections and corrective actions in the order listed.
b. This manual cannot list all malfunctions that may occur, nor all test or inspections and corrective actions. If
a malfunction is not listed or is not corrected by listed corrective actions, notify your supervisor.
Table 6-2. TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1. BLOWER DOES NOT OPERATE.
Step 1. Check for unplugged power cord.
(a) If power cord is plugged in, proceed to step 2.
(b) Plug in power cord.
Step 2. Check for tripped circuit breaker.
(a) Reset circuit breaker.
(b) Replace unit,
2. BLOWER BLOWS AIR BUT HEATER DOES NOT OPERATE.
Check for tripped heater thermostat.
Allow unit to cool for 30 minutes.
6-10. MAINTENANCE PROCEDURES. There are no operator maintenance procedures assigned for this
equipment.
Change 2 6-9
