TM 5-3610-253-14
Table 5-4. OPERATOR PREVENTIVE MAINTENANCE CHECKS AND SERVICES - Cont
(Number) - Hundreds of Hours
AN - Annually
W - Weekly
B - Before
S - Semiannually
M - Monthly
D - During
BI - Biennially
Q - Quarterly
A - After
For Readiness
ITEM TO BE INSPECTED
Reporting,
ITEM
Equipment Is
PROCEDURE
NO.
Not Ready/
Available If:
PAPER CUTTER - Cont
Inspect Backgauge - Cont
B
7
locking
6. Turn the knife change lever to the right,
the clamp in the down position.
7.
Pull out on false clamp release pins, and
lock them off.
Turn the knife change lever to the left,
8.
raising the clamp.
Remove false clamp and insert it into its
9.
holder under the table.
Backgauge
Pull backgauge control knob outward. Backgauge
10.
does not
should move forward under clamp and stop short
move under
of knife.
clamp.
Press button in center of backgauge control knob.
11.
Move backgauge back approximately halfway.
Press backgauge control knob inward until manual
12.
drive gears engage.
5-47
