TM 5-3610-253-14
NOTE
Note position of motor drive sprocket on old motor shaft and reinstall in
some position on new motor shaft.
Loosen setscrew and remove motor drive sprocket and key from motor
s.
shaft.
t.
Reinstall motor drive sprocket and key on new motor shaft and tighten
setscrew.
u.
On the flat work surface, aline new motor with cutting head, and two
socket head capscrews and two hex head bolts in motor mounting
brackets.
Tighten jam nuts on the two hex head mounting bolts.
v.
Reinstall chain on drive motor sprocket and cutting head sprocket.
w.
Secure with master link.
WARNING
Serious injury may occur from failure to observe proper lifting practices.
The motor and cutting head are heavy and awkward to handle. A minimun
of three people are required to perform the following step. (Two people
will lift, as the third guides the assembly into the shredder cabinet).
Carefully lift motor and cutting head assembly into shredder cabinet.
x.
Reinstall mounting bolts which secure cutting head to cabinet.
y.
z.
Reinstall wastebasket overfill switch on its mounting bracket.
4-36
