TM 5-3610-253-14
Inspect cutters. Each cutter has four cutting surfaces. Rotating
g.
cutter or exchanging upper and lower cutters will bring new edge to
bear against wire. When all four cutting surfaces are worn, new
cutter must be used.
h. Replace lower cutter (center slot facing cutter head) by sliding
into slot and pushing down.
Replace upper cutter (center slot facing cutter head) by sliding
i.
into slot.
Lower wire cutter retainer to lock cutters in position and thread wire.
j.
CAUTION
If force is used in closing stitcher head door, the stitcher will be
damaged. If door binds, manually depress supporter until the swivel
clears supporter and the door will close.
k. Close stitcher head door.
Release pawl and rotate pulley manually to the right to check cutting
l.
action. Stitcher head must operate freely.
Replace rear belt guard and tighten screw.
m.
Plug in power cord.
n.
3-30
