TM 5-3610-253-14
Pull supporter spring rod free from supporter.
(6)
Rotate drive pulley to the right until release hole in drive is visible.
(7)
Insert driver release pin in release hole in driver.
(8)
Push driver release pin in and push driver from bottom of bender bar.
(9)
Change driver.
(10)
Insert driver in bottom of bender bar; then slide upward until driver
(11)
stops.
(12) Depress tension spring with release pin and slide driver until it
clicks into place.
Reconnect supporter spring.
(13)
(14) Lift pawl to engage clutch and release brake; then manually rotate
pulley at least twice to be sure head operates freely.
(15) Reinstall belt rear guard and tighten screw.
3-17
