TM 5-3610-253-14
Organizational troubleshooting procedures cover the most common malfunctions
that may be repaired at the organizational level. Repair or adjustment requiring
specialized equipment is not authorized unless such equipment is available.
Troubleshooting procedures used by the operator should be conducted in addition
to the organizational troubleshooting procedures.
b. This manual cannot list all the possible malfunctions or every possible test/
inspection and corrective action. If a malfunction is not listed or is not
corrected by a listed corrective action, notify your supervisor.
For unidentified malfunctions, use the facing schematic or the foldout
located at the end of this manual for further fault analysis.
d. If any component of the Finishing Section does not power up when turned on,
verify that 120 V ac is present at the receptacle. If voltage is not present, plug
equipment into receptacle with power available and proceed with equipment trouble-
shooting. Perform no-power troubleshooting procedures for dead receptacle (Table
1-57
