TM 5-2330-305-14
6. Apply brakes and hold application. The angle on the slack
adjusters should not be less than 90 degrees.
WHEN ADJUSTING BRAKES WITH SPRING BRAKE CHAMBERS,
DO NOT REMOVE PUSHROD CLEVIS PIN OR LOOSEN MOUN-
TING NUTS UNLESS CHAMBER IS DISABLED BY CAGING.
NOTE
All slack adjusters should be set
at the same approximate angle.
7. Adjust angle by shortening or lengthening pushrod at clevis yoke as
required.
8. Repeat procedure for remaining five brakes.
9. Lower jack.
Disconnect gladhands to set chassis brakes and remove
wheel chocks.
4-43
