TM 5-2330-305-14
4. Remove bolt which secures trailing arm to bottom of air spring.
N O T E
Male pipe end of air hose does not
swivel
To remove the male end of
an air hose from a comonent, dis-
connect the swivel at the other end
of the air line. Then disconnect
the air line from the chassis so
that the male pipe end turns freely.
5. Disconnect air line at top of air spring.
6. Remove two nuts which secure top of air spring to rear mounting
assembly.
7. Remove air spring.
8. Install new air spring and secure to rear mounting assembly with
two nuts and torque to 60-70 ft lbs.
9. Secure bottom of air spring to trailing arm with bolt and torque to
60-70 ft lbs.
NOTE
Be sure air spring does not
twist while tightening bolt.
10. Reconnect air line at top of air spring using thread sealant.
11. Reconnect control link to height control valve and secure with nut
and bolt.
12. Retract chassis leveling jacks.
NOTE
When leveling jacks have
been retracted, be sure
height control valve has
allowed air spring to be
inflated.
4-33
