9.
8.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
TM 5-2330-305-14
Turn release stud assembly nut with wrench until compression spring is
fully caged.
While doing so, check visually to make certain the pushrod
(adapter pushrod or service pushrod) is retracting while tightening the
release stud assembly nut.
Remove cotter pin and clevis pin from brake adjuster.
Remove two retahing nuts and washer, and remove brake chamber.
Install new brake chamber to brackets and secure with nuts and washers.
Reinstall clevis and clevis pin to brake adjuster and secure with cotter
pin.
Loosen release stud nut, and remove stud.
Turn release stud to left to release cross pin and remove stud.
Reinstall release stud to side pocket, and secure with nut and washer.
Reinstall chamber cap.
Reinstall air hose and tighten connector assembly.
Adjust brakes. (4.4.1.21)
Pressurize system and check for leaks by coating fittings with soapy
water solution and inspecting for presence of bubbles.
4-19
