TM 5-2330-305-14
NOTE
Male pipe end of air hose does not
swivel. To remove the male end of
an air hose from a conponent, dis-
connect the swivel at the other end
of the air line. Then disconnect
the air line from the chassis so
that the male pipe end turns freely.
2. Loosen connectors and remove air hoses.
3. Remove cap from chamber.
4.
Remove release stud assembly from side pocket by removing the release nut
and washer from the release stud and sliding out the release stud.
5. Insert release stud through opening (where cap was removed) in the spring
chamber and insert into pressure plate.
4-17
