TM 5-2330-305-14
CHAPTER 4
ORGANIZATIONAL MAINTENANCE INSTRUCTIONS
Section I. REPAIR PARTS, SPECIAL TOOLS AND EQUIPMENT
4.1.1 COMMON TOOLS AND EQUIPMENT For authorized common tools and equipment, refer
to the Modified Table of Organization and Equipment (MTOE) applicable to your unit.
4.102 SPECIAL TOOLS; TEST, MEASUREMENT AND DIAGNOSTIC EQUIPMENT; AND SUPPORT
EQUIPMENT No special tools; test, measurement, and diagnostic equipment; or sup-
port equipment are required for the repair of this equipment at the Organizational
level of maintenance.
4.1.3 REPAIR PARTS
Repair parts for this equipment are listed in the Repair Parts
and Special Tools List (RPSTL), TM 5-2330-305-24P covering Organizational and
Direct/General Support maintenance.
Section II. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES
4.2.1 INTRODUCTION
a.
Always keep in mind the WARNINGS and CAUTIONS when performing PMCS. Table
4-1 lists the PMCS procedures to be performed by Organizational maintenance.
Be sure to perform the PMCS at the frequency indicated by the INTERVAL codes
in the table.
b.
If your equipment fails to operate, troubleshoot with the proper equipment.
Report any deficiencies in accordance with TM 38-750.
N O TE
If the equipment must be kept in continuous operation,
check and service only those items that can be checked and
serviced without disturbing operation. Make the complete
checks and services when the equipment Can be shut down.
c.
The numbers found in the ITEM NUMBER column shall be used as a source of item
numbers for the TM NUMBER column on DA Form 2404, Equipment Inspection and
Maintenance Worksheet, in recording the results of PMCS
4-1