TB 1-4920-443-35
AEDATS II T53 ALIGNMENT WORKSHEET
(17)T55 Electric Torque System (Note T55 flight harness must be connected)
(Refer to page 68 step 54)
(a) Access connector at engine T55 Flight Harness (20090776-1)
2 Jumper pins Z and A together, and connect to voltage source.
3 Connect pin Y to the + terminal of millivolt source.
4 Activate Torque Power Switch on indicator panel.
(b) Set the Millivolt source to the following levels:
Input
Reading
Analog Gauge
+/- 6 mv
percentage
+/- 2%
230
50
____________
325
70
____________
430
100
____________
(c) If out of tolerance use shorting cable to set 0
(d) Install shorting cable between T55 flight harness (20090776-1) and engine
DYNO OIL SAMPLE
VAROC 35
YES_______
INIT_______
NO______INIT_____
DYNO OIL SAMPLE
VAROC 250
YES_______
INIT_______
NO______INIT_____
141
