TB 1-4920-443-35
Table 18-3 TI Channel 1 Meter Amplifier Controls
CHAN 1 XDUCER switch to
VEL
CHAN 1 MODE switch to
VEL
CHAN 1 RANGE switch to
5
CHAN 1 OUTPUT switch to
AVG
(8) Repeat steps 2 through 7 for the remaining channels 2, 3, 4, and 5.
(9) Connect jumper wire between pins A and B on the connector labeled VIB1 of cable 20090778-1.
(10)Verify that TI channel 1 bar graph and digital display indications are ZERO. Adjust the Digital Bar
graph Indicator's ZERO controls R4 as necessary. Disconnect the jumper wire.
(11)Repeat steps 9 and 10 for TI channels 2 through 5 using the following connections.
Table 18-4 T1 Channels 2 through 5
Channel
Plug
Plug Pins
2
Cable 20090778, Vib 2
A, B
3
Cable 20090778, Vib 3
A, B
4
Cable 1464D297, 40J
A, B
5
Cable 1464D297, 41J
A, B
Note: Cable 1464D297 is on the V-250 Dynamometer.
(12)Set the TI filter switch to cal and adjust TI CAL ADJ control to 105 on the digital display. Repeat for
all channels.
Table 18-5 Standard Sensitivity Ratings
Model
TI indication
4-118-0002
105
4-128-0001
60.5
(13)Set TI FILTER switch to SENS position for all channels and adjust each channel SENS ADJ control
for an indication of 150 on each display.
(14)Set TI mode switches to VEL on each channel, range switch to 5.0 and filter switch to OUT.
(15)Connect the CEC 2700 Signal Source J2 connector pins A(+) and B(-) to pins A (+) and B (-) of
connector VIB1 on cable 20090778-1. Ensure that CEC2700 signal source is set to AUG.
(16)Maintain the CEC 2700 oscillator at a constant output frequency (100 Hz) while changing the output
millivolt level to the values listed below.
(17)At each output level, verify that the TI vibration meter indicator and AEDATS reads within the
tolerance limits listed.
Table 18-6 TI Vibration Meter Indications
Output Level
Vibration Meter
TI Indication
AEDATS
(Hz)
(mV RMS)
Tolerance Limits
(inches/sec)
Readings
(in/sec)
CH 1 CH 2 CH 3
CH 4
CH 5
100
116.5
0.9 to 1.1
100
233.0
1.9 to 2.1
100
350.0
2.9 to 3.1
100
466.0
3.9 to 4.1
100
583.0
4.9 to 5.1
(18)Repeat steps 17 & 18 for all remaining amplifier channels, 2 to 5, using the following connections:
Table 18-7 T1 Channels 2 through 5
Channel
Plug
Plug Pins
2
Cable 20090778, Vib 2
A, B
3
Cable 20090778, Vib 3
A, B
4
Cable 1464D297, 40J
A, B
5
Cable 1464D297, 41J
A, B
Note: Cable 1464D297 is on the V-250 Dynamometer.
13
