TB 1-4920-443-35
EQUIPMENT REQUIREMENTS
3. Equipment Required. Table 2
identifies the specific equipment to be
used in
this alignment procedure.
Instruments used in this procedure are contained in the FEDS Calibration Kit, P/N 20090845. Alternate
equipment may be used at the discretion of the using laboratory, provided that substitute equipment is of
equal or better precision than that contained in the Calibration Kit. All test equipment should bear evidence of
current calibration. The accuracies listed in table 1 provide a four-to-one ratio between the standard and TI.
Where the four-to-one ratio cannot be met, the true accuracy of the equipment selected is shown in
parenthesis. Refer to the commercial operator's manuals supplied with the calibration kit for operating
instructions of the equipment.
4. Accessories Required. The accessories required for this alignment are common usage accessories, issued
as indicated in paragraph 3 above, and are not listed in the alignment procedure.
Part No.
Description
Where Used
3928-1-0-1/USA
Eurotron 2000+ Calibrator
Various Systems
318
Weight Hanger
4238P
Vacuum Pump
Pressure System
44-1322-2081-005
Pressure Regulator
Pressure System
50190-0804
BF Goodrich box
T53/55/T63 Torque
Measurement System
5SE00491-2
Wire, Type Kx
Temperature System
5SE01412
Torque Arm
Pressure Calibrator 200/500/1000 PSI (0.05%)
6076P
Pressure Systems
Thermocouple Calibrator, Analogic Digi-Cal II (0.03%)
6803T
Temperature System
Digital Electro-Pneumatic Calibrator (0.1%)
7095P
Pressure System
Voltage Source (0.05%)
7929E
Vertical Scale
7975E-B/
Various Systems
4213E
Decade Box 0-999.9 ohms (0.025%)
8142B
RTD System
8422E
Flow, Speed, &
2700-0001
Vibration Systems
9100
Weight 50 lbs.
NCA-11-FCS/3A
Speed System
MIL-C-22491
Pressure System
SSE00491-1
Wire, Type Jx
Temperature System
LTCT 29089-03
Test Set, Flight Line
714 Torque
0368937-0001
CEC Vibe Extender Card
Vibrator System
9778124
Extender Card
T53/T55/T63 Torque
Measurement System
Limit Control Panel