TM 5-6675-331-14&P
2-4.
PREPARATION FOR USE. (Cont'd)
i.
Installing boot. (Cont'd)
(26)
Shut down the HMMWV and set parking brake.
(27)
Attach boot to tent using velcro strips and straps located on boot and around tent door.
(28)
Reinstall ladder.
NOTE
Bottom of ladder should rest on reinforced area of boot.
j.
Preparing shelter for use.
NOTE
Floor bracket has three positions: OPEN-for removal or installation of floor bracket; LOCK-for locking floor
bracket and PLUG-in this position, installation holes are covered.
(1)
Turn screw (1) until floor bracket lock (2) is in open position. Remove floor brackets (2) and stow in trailer.
Turn screw until floor bracket lock (2) is in the plug position.
(2)
Press tang at rear of each buckle to loosen straps around chairs. Set chairs in tent and in shelter as
needed.
(3)
Reach under shelf and pull writing surface forward until it stops. Pull down on rear of writing surface to flip
surface up.
(4)
Ensure that main switch, environmental control unit, and all circuit breakers are OFF.
2-41
