TM 5-6675-328-14
SECTION III OPERATOR MAINTENANCE
1-8. LUBRICATION INSTRUCTIONS.
a. Lubrication instructions for the Maintenance Section are contained in LO 5-6675-328-12, Lubrication Order,
Maintenance Section, Topographic Support System. The intervals and man-hours specified in the Lubrication Order are
based on normal operations. During inactive periods, lubrication periods may be extended with adequate preservation.
b. Topographic equipment and all optical equipment require special care in lubrication. When a specified lubricant is
called for, substitutions are not authorized. Minimum amounts of lubricant are to be used and all excess lubricant is to be
immediately removed. Spray lubricants must not be used in the vicinity of optical equipment unless optics are
completely protected. No lubricant is to be applied unless a thorough cleaning is conducted first to remove dirt, dust, or
abrasive material.
c. Be sure that you refer to the appropriate chapter before any equipment is stored after use. Make sure that the
temperature has stabilized and that required lubrication after use is accomplished.
1-9. TROUBLESHOOTING PROCEDURES.
a. The table lists the common malfunctions which you may find during the operation or maintenance of the
Maintenance Section or its components. You should perform the tests/inspections and corrective actions in the order
listed.
b. This manual cannot list all malfunctions that may occur, nor all test or inspections and corrective actions. If a
malfunction is not listed or is not corrected by listed corrective actions, notify your supervisor.
1-44
