TM 5-6675-328-14
b. Insert chuck wrench into chuck and rotate to the right to tighten chuck jaws around drill bit. Remove chuck
wrench.
c. Measure height of material to be drilled, plus approximately 1/8 in. (3 mm). This is the working distance.
d. With table in its lowest position, loosen table locking wheel.
CAUTION
Fasten equipment to feed tray to prevent rotation.
e. Move table assembly until working distance from table to drill bit is achieved and drill bit is centered on table.
f. If larger distance between table and drill bit is needed, loosen motor locking wheel and move motor while
keeping drill bit centered on table.
g. To adjust drilling depth, rotate feed wheel until desired drilling depth is achieved; loosen setscrew on locking
collar, move collar up shaft to table bracket, and tighten set screw.
NOTE
If desired, drill press may be operated without the foot controller. Plug motor power cord in
outlet and operate with power switch.
h. Attach foot controller and plug in power cord.
i. Turn power switch on and operate drill with foot controller.
j. Rotate feed wheel to the right to drill hole.
3-7. OPERATION UNDER UNUSUAL CONDITIONS. This equipment is designed for operation only in a control led
environment.
3-9
