TM5-6675-326-14
Table 1-5. Direct/General Support Troubleshooting - Continued
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
4. RECEPTACLES DO NOT OPERATE BUT CIRCUIT BREAKERS ARE ON - Continued
Step 2.: Check to see if voltage meter, frequency scale, and CORRECT PHASE lamp indicate correct
power.
Notify your supervisor for service of power supply at source.
5. CIRCUIT BREAKERS TRIP CONTINUALLY.
WARNING
ELECTRICAL SHOCK
Turn OFF main circuit breaker before inspecting or servicing circuit breakers
or receptacles. Failure to do so may result in death or serious injury.
Step 1. Check to see if receptacles are overloaded.
Reconnect equipment to different receptacles.
Step 2. Check to see if receptacles are damaged.
Replace receptacles (para 1-15.6).
1-19 DIRECT/GENERAL SUPPORT MAINTENANCE PROCEDURES.
This section contains step-by-step instructions covering direct/general support maintenance procedures.
1-19.1 Repair Personnel/Cargo Door Handle
PERSONNEL REQUIRED: 1 Wheel vehicle repairer MOS 63W
TOOLS: No. 3 cross-tip screwdriver
No. 4 cross-tip screwdriver
Needle-nose pliers
15/16-in. combination box and open end wrench
Ball-peen hammer
Center punch
1-64
Change 1
