TM5-6675-326-14
12-4.2.6 Still Picture Camera - Continued
b .
c .
d .
e .
f .
g .
h .
i .
j .
( 2 ) C h o o s e f i l m t y p e . O p e n f i l m p a c k.
(3) Load film pack by opening camera back all the way and
pressing film pack down into camera.
(4) Close camera back.
Make sure both sides latch.
(5) Pull black tab of safety cover all the way out of the
camera.
A white tab should now show in slot.
Change scene setting selector by pushing lever to left or
r i g h t .
NOTE
For outdoor or flash picture, set to 3000 for black
and white film.
F o r d i m l i g h t , set to 3000 ER.
Set
t o 7 5 f o r c o l o r f i l m.
Attach flashcube by pressing into flash socket. Wind
f l a s h c u b e u n t i l a s t o p i s f e l t .
Observe object in viewfinder, and frame desired object in
a p p r o p r i a t e l i n e s .
Estimate range in feet to object, and set lens to estimated
r a n g e.
Press shutter release button.
Remove exposed film with a firm, steady pull.
Wait 60 seconds before removing paper backing.
Coat black and white prints with sealer.
To operate still picture camera in cold (under 65°F, 18°C)
weather use the cold pack on the back of the camera.
(1) Remove cold pack from back of camera, and place in
inner pocket.
(2) When exposed film is removed from the camera, put it
i n c o l d p a c k.
Put cold pack back in pocket.
(3) After 60 seconds, remove exposed film.
12-19
