TM5-6675-326-14
7-13.2 Replace Power Switch - Continued
b .
Remove screws and nuts holding stainless steel tank and casing
t o c h a s s i s.
c .
L i f t s t a i n l e s s s t e e l t a n k a n d c a s i n g f r e e.
Set aside.
N O TE
Do not disconnect wires to transducer.
d .
Remove screws and nuts holding circuit board to chassis.
e.
Tag and disconnect power cord wire from power switch.
f .
Tag and disconnect circuit board wire from power switch.
g.
Press sides of defective power switch and remove from chassis.
INSTALLATION:
a.
Install new power switch in chassis. Push power switch until
tabs lock
b.
Reconnect
c . R e c o n n e ct
d.
Reinstall
e . R e i n s t a l l
i n t o h o l e.
circuit board wire to power switch.
Remove tag.
power cord wire to power switch.
Remove tag.
circuit board to chassis with screws and nuts.
stainless steel tank and casing.
Secure with nuts
and screws.
f .
F i l l s t a i n l e s s s t e e l t a n k 1 / 3 f u l l w i t h w a t e r .
g .
Plug in power cord.
Turn power ON.
Be sure water surface agitates.
7-13
