TM5-6675-326-14
6-6.1 Assembly and Preparation for Use - Continued
n.
If using point counter pen, remove from case.
Plug into POINT
COUNT. input jack on auto-scaler back panel.
o.
If using linear measuring probe, remove from case. Plug into
E 1 encoder socket on auto-scaler back panel.
p .
Plug both power transformers into 110 vac outlets.
6-6.2 OPERATING PROCEDURES.
6 - 6 . 2 . 1 G e n e r a l.
The QPS provides for estimation of distance, area,
perimeter, and volume of geographic shapes found on maps, drawings, and
aerial photographs.
I t i s p r e c i s e l y s e t a n d a l i n e d a t t h e f a c t o r y.
Factory determined values , necessary for accurate calculations and
estimations, are different for each QPS. The formulas and values on the
Calibration Records Sheet, provided with the equipment, must be used in
order to obtain correct results from measurements.
6-6.2.2 Index of Operating Procedures
Procedure
Alinement of Linear Measuring Probe
Alinement of Planimeter With Lens Tracing
Assembly
Alinement of Planimeter With Needle Tracing
Assembly
Area Measurements on Aerial Photographs of
Unknown Scale or Magnification
Diverging Volume Runs
Installing Blank Cartridge in Point Counter
Pen
I n s t a l l i n g P a p e r i n C a l c u l a t or
Layout Work With Linear Measuring Probe
Linear Measurements on Aerial Photographs
of Unknown Scale or Magnification
Linear Measuring Probe Measurements Without
t h e C a l c u l a t or
Loading Magnetic Cards
Paragraph
6 - 6 . 2 . 16
6 - 6 . 2 . 14
6 - 6 . 2 . 15
6 - 6 . 2 . 33
6 - 6 . 2 . 2 8
6 - 6 . 2 .9
6 - 6 . 2 .8
6 - 6 . 2 . 2 3
6 - 6 . 2 . 32
6 - 6 . 2 . 2 4
6 - 6 . 2 . 1 0
Page
6-52
6 - 50
6-52
6 - 88
6 - 80
6 - 45
6 - 44
6-67
6-86
6 - 69
6-46
6-37