TM 5-6675-326-14
5-8.4 Replace Glass Surface - Continued
WARNING
Use care when handling damaged glass. Failure to do so may result in serious
cuts.
d.
Remove damaged glass surface.
INSTALLATION:
a.
Install new glass surface.
b. Turn clips to secure glass surface. Aline holes, and reinstall screws. Tighten all screws.
c.
Plug in power cord, and turn power ON.
Section IV. ORGANIZATIONAL MAINTENANCE
5-9 REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE); AND
SUPPORT EQUIPMENT.
5-9.1 For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment
(MTOE) applicable to your unit.
5-9.2 Special tools, TMDE, and support equipment required at the organizational level are indicated in Appendix
B, Section Ill of this manual.
5-9.3 Repair parts are listed and illustrated in the Repair Parts and Special Tools List (TM5-6675-326-24P) covering
organizational maintenance for this equipment.
5-10 ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS).
There are no PMCS at the organizational level for the portable tracing/scribing board.
5-11 ORGANIZATIONAL TROUBLESHOOTING.
There is no troubleshooting at the organizational level for the portable tracing/scribing board.
5-16
Change 1
