TM 5-6675-325-14
m.
Remove foot switch from carrying case.
Plug into CLEAR, INIT, or ACCU input
jack on auto-scaler back panel.
n.
If using point counter pen, remove from case. Plug into POINT COUNT jack on
auto-scaler back panel.
o.
If using linear measuring probe, remove from case.
Plug into E1 encoder
socket on auto-scaler back panel.
p.
Plug both power transformers into 120 V ac outlets.
5-6.2 Operatinq Procedures.
The QPS provides for estimation of distance, area,
perimeter and volume of geographic shapes found on maps, drawings, and aerial
photographs.
It is precisely set and alined at the factory. Factory determined
values, necessary for accurate calculations and estimations, are different for each
QPS. The formulas and values on the Calibration Records Sheet, provided with the
equipment, must be used in order to obtain correct results from measurements.
INDEX OF OPERATING PROCEDURES
PROCEDURE
Alinement of Linear Measuring Probe
Alinement of Planimeter with Lens Tracing Assembly
Alinement of Planimeter with Needle Tracing Assembly
Area Measurements on Aerial Photographs of Unknown Scale
or Magnification
Diverging Volume
Installing Blank
Installing Paper
Runs
Cartridge in Point Counter Pen
in Calculator
Layout Work in Linear Measuring Probe
Linear Measurements on Aerial Photographs of
Unknown Scale or Magnification
Linear Measuring Probe Measurements without
the calculator
Loading Magnetic Cards
Manual Program Loading
Measuring Areas to be Added and/or Subtracted
Measuring Areas with Planimeter
PARAGRAPH
5-6.2 N
5-6.2 l
5-6.2 M
5-6.2 ae
5-6.2 Z
5-6.2 g
5-6.2 f
5-6.2 U
5-6.2 ad
5-6.2 V
5-6.2 h
5-6.2 i
5-6.2 t
5-6.2
0
5-39
