TM 5-6675-325-14
4-13. SERVICE UPON RECEIPT.
4-13.1
Checking Unpacked Equipment.
a.
Inspect the equipment for damage incurred during shipment. If the equipment
has been damaged, report the damage on DD Form 6, Packing Improvement Report.
b. Check the equipment against the packing list to see if the shipment is
complete.
Report all discrepancies in accordance with the instructions of DA Pam
738-750.
c.
Check to see whether the equipment has been modified.
4-14.
ORGANIZATIONAL
PREVENTIVE
MAINTENANCE
CHECKS
AND
SERVICES.
There
are no organizational PMCS assigned for this equipment.
4-15. ORGANIZATIONAL TROUBLESHOOTING PROCEDURES.
a.
Organizational troubleshooting procedures cover the most common malfunctions
the may be repaired at the organizational level.
Repair or adjustment requiring
specialized equipment is not authorized unless such equipment is available.
Troubleshooting procedures used by the operator should be conducted in addition to
the organizational troubleshooting procedures.
b. This manual cannot list all the possible malfunctions or every possible test/
inspection and corrective action.
If a malfunction is not listed or corrected by a
listed corrective action, notify your supervisor.
c.
For unidentified malfunctions, use the following schematics or the foldout
located at the end of this manual for further fault analysis.
d.
If the vertical reflecting projector does not power up when turned up, verify
that 120 V ac is present at the receptacle.
If voltage is not present, plug
equipment into receptacle with power available and proceed with equipment
troubleshooting.
Perform no-power procedures for dead receptacle (Table 1-4).
4-19
