TM 5-6675-325-14
c.
Grasp lightbulb firmly, press horizontally against spring-loaded
sockets and remove.
d.
Grasp new lightbulb with clean rag or gloved hands, and install into
sockets.
e.
Reinstall heat-reflecting glass and secure with retaining screws.
f. Plug in power cord.
Section IV ORGANIZATIONAL MAINTENANCE
4-11. LUBRICATION INSTRUCTIONS. This equipment does not require lubrication.
4-12. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIP-
MENT(TMDE); AND SUPPORT EQUIPMENT.
4-12.1 Common Tools and Equipment.
For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
u n i t .
4-12.2 Special Tools: Test, Measurement, and Diagnostic Equipment: and Support
Equipment.
Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
4-12.3 Repair Parts.
Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-6675-325-24P covering organizational maintenance for
this equipment.
4-18
