TM 5-6675-324-14
ORGANIZATIONAL MAINTENANCE
Section IV
This equipment does not require lubrication.
LUBRICATION INSTRUCTIONS.
6-12. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE) ; AND SUPPORT EQUIPMENT.
6-12.1 Common Tools and Equipment. For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
6-12.2 Special Tools: Test, Measurement, and Diagnostic Equ ipment: and Support
Equipment. Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
6-12.3 Repair Parts. Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 6-6675-324-24P covering organizational maintenance for
this equipment.
6-13.1 Checking Unpacked Equipment.
Inspect the equipment for damage incurred during shipment. If equipment has
been damaged, report the damage on DD Form 6, Packing Improvement Report.,
b. Check the equipment against the packing list to see if the shipment is
complete. Report all discrepancies in accordance with the instructions of DA Pam
738-750.
Check to see whether the equipment has been modified.
c.
no organizational PMCS procedures assigned for this equipment.
Organizational troubleshooting procedures cover the most common malfunctions
that may be repaired at the organizational level. Repair or adjustment requiring
specialized equipment is not authorized unless such equipment is available. Trouble-
shooting procedures used by the operator should be conducted in addition to the
organizational troubleshooting procedures.
