Section III. Operator Maintenance - TM-5-6675-324-14-20138

TM 5-6675-324-14

i. Place calculator case, calculator power transformer, magnetic card pack,

and manufacturer's manual in large calculator case.

j. Close and secure both cases.

5-7. OPERATION UNDER UNUSUAL CONDITIONS. This equipment is designed for operation

only in a controlled environment.

Section III Operator Maintenance

5-8. LUBRICATION INSTRUCTIONS.

NOTE

These lubrication instructions are mandatory.

Apply one drop of watch oil (Item 15, Appendix E) to drive gears of linear measuring

probe quarterly.

5-9. TROUBLESHOOTING PROCEDURES.

5-9.1 The table lists the common malfunctions which you may find during the

operation or maintenance of the QPS. You should perform the test/inspections and

corrective actions in the order listed.

5-9.2 This manual cannot list all malfunctions that may occur, nor all tests or

inspections and corrective actions. If a malfunction is not listed or is not

corrected by listed corrective actions, notify your supervisor.