TM 5-6675-324-14
NOTE
Do not remove assembly from copier until exposure lamp leads are disconnected.
h. Disconnect exposure lamp leads.
Remove screw and thermistor bracket.
i.
Remove screw and cable clamp.
j.
k. Disconnect thermistor leads at connector points.
Remove defective thermistor.
1.
Install new thermistor into bracket and tighten screw.
m.
Connect thermistor leads.
n.
Reinstall cable clamp.
o.
Reinstall reflector and exposure lamp assembly.
P.
Reconnect exposure lamp leads to each end of lamp.
q.
Reinstall copy belt by sliding it over rollers from left to right.
r.
Center belt on roller.
4-67
