TM 5-6675-324-14
b. Open and remove top cover.
Check drive belt tension by applying moderate pressure to center of
c.
belt. Belt should deflect a maximum of 3/16 in. (4.7 mm) and minimum of
1/16 in. (1.6 mm).
If above condition is not met, loosen two motor mounting screws. If
d.
belt is too slack, move motor toward front of copy machine. If belt is
too tight, move motor toward rear of copy machine until tension is cor-
rect. Retighten motor mounting screws.
Reinstall top cover and close.
e.
f. Plug in power cord.
4-64
